Eiki LC-W4 Owner's Instruction Manual page 60

6
This projector has three Light-Block Sheets. Use the Light-Block Sheet corresponding with the lens. (Refer
to the list below.)
Set the Light-Block Sheet through the lens.
Make sure the shape of the Light-Block Sheets are correct and be sure to set them as shown in the Fig. 8.
NOTE:
● Be sure to set each Light-Block Sheet as shown in Fig. 8.
● Make sure the mark (TOP and BACK) on the Light-Block Sheets are correct and set them properly.
Light-Block Sheets for each lens.
Lens Model No.
LNS-S02, LNS-S02Z, LNS-W04
LNS-M01, LNS-T02, LNS-W02,
LNS-M01Z, LNS-W02Z, LNS-S01,
LNS-W03, LNS-W07
LNS-W01, LNS-T01, LNS-W01Z,
LNS-T01Z, LNS-S03,
LNS-W06, LNS-W05
LIGHT BLOCK SHEET
Make sure the sheet figure is
correct and put in proper position.
E
Type No. (Part No.)
TYPE FD1 (610 322 8051)
TYPE FE1 (610 322 7269)
TYPE FF1 (610 322 7788)
Not include Light-Block Sheet
Mounting Base and screws.
For Models
LNS-W01, LNS-W01Z, LNS-T01, LNS-T01Z
LIGHT BLOCK SHEET
Make sure the sheet figure is
correct and put in proper position.
Mount the Light-Block Sheet
with two (2) screws.
- 4 -
Fig-8