Eiki LC-W4 Owner's Instruction Manual page 59

4 Replace the Lens Cap on the rear (mounting side) of the Projection Lens and mount a lens on
the Lens Attachment with four (4) Screws. (Use the screws attached on the lens.)
Connect the Lens Motor Lead connector to the socket on the right-top of the Lens Attachment
(Motor Driven Lens only). See Fig. 5.
When installing the LNS-W01, LNS-W01Z, LNS-T01, LNS-T01Z, be sure to mount the lens and
the Light-Block Sheet Mounting Base on the Lens Mounting Bracket. (See Fig. 8)
LENS LOCK SCREW
DRIVER
IN THE LENS
Part No. (610 275 6029)
LENS
ATTACHMENT
LENS MOTOR LEAD
5 Grasp (release lock) the Lens Lock Lever and turn it fully upward. (See Fig. 6.)
Install the lens into the projector. Grasp the Lens Lock Lever and turn the Lever fully downward
until lever is Locked (clicked position) properly. (See Fig. 7.)
When installing the Motor Driven Lens, be sure to mount the Lens Motor on the right side. (See Fig. 5.)
After installing the lens, make sure the lens is not loose and properly installed.
LENS LOCK RELEASE
Grasp (unlock)
the Lens Lock
Lever and pull
upward.
LENS ATTACHMENT
LIGHT-BLOCK SHEET
MOUNTING BASE
Part No. (610 303 9596)
Kit parts with two (2) screws.
Lens attachments For each lens.
LNS-W01, LNS-W01Z, LNS-W02Z,
LOCATE MOTOR
LNS-W03, LNS-T01, LNS-T01Z,
ON RIGHT SIDE
LNS-T02, LNS-S02, LNS-S02Z,
LNS-S03, LNS-M01Z, LNS-W04,
LNS-W05, LNS-W06, LNS-W07
LNS-W02, LNS-M01, LNS-S01
SOCKET
CONNECTOR
Fig-5
Fig-6
Lens Model No.
LENS LOCK
Grasp (unlock) the
Lens Lock Lever and
fully pull downward
until it is locked
(clicked).
- 3 -
LENS LOCK
LEVER
Fig-4
LENS ATTACHMENT
TYPE No. (PART No.)
Lens Attachment 01
POA-LNA-01
(610 303 8742)
Lens Attachment 02
POA-LNA-02
(610 304 6228)
Fig-7
E