Starting The Configuration Utility Program - Lenovo ThinkServer RD240 Hardware Maintenance Manual

Figure 67. Mini SAS cable with four SAS connectors and one SGPIO connector
Note: The number on the label for each of the four SAS signal cables indicates the sequence when you are
connecting the cables to the corresponding SAS connectors (0-3) on the system board.
SAS connector
6
7
8
9

Starting the Configuration Utility program

During the POST, when the message "Press Ctrl-C to start LSI Logic configuration Utility..." is displayed, press
Ctrl+C to enter the Configuration Utility main menu. Press Enter and the Adapter List window is displayed. In
this window, you can view the controller list, view the hard disk drive information, and configure RAID.
When working with this program, you must use the keyboard. The keys used to perform various tasks are
displayed at the bottom of each screen.
Table 39. Items in the Adapter List window
Adapter
PCI Bus
Dev/Fnc
FW Revision
Status
Boot Order
You can press Alt+N to switch to the Global Properties window to set the properties of boot and interrupt.
SAS signal cable label
Item
System board SAS connector
P1
P2
P3
P4
Description
The SAS adapter(s) detected
The PCI bus number assigned to the adapter
The PCI device or function assigned to the adapter
The current firmware version
Indicating whether the adapter on the boot list is enabled
or disabled
Indicating the boot sequence. You can change the
sequence by pressing + or -.
Chapter 9
SAS connector 0
SAS connector 1
SAS connector 2
SAS connector 3
125
.
Configuring the server