Installing The Power Supply - Lenovo ThinkServer RD240 Hardware Maintenance Manual

Installing the power supply

Attention: Do not open your server or attempt any repair before reading and understanding the "Safety information"
on page iii and "Guidelines" on page 35.
This section provides instructions on how to install a power supply.
When you install a power supply, observe the following precautions.
DANGER
Hazardous moving parts. Keep fingers and other body parts adway.
Statement 8
CAUTION:
Never remove the cover on a power supply or any part that has the following label attached.
Hazardous voltage, current, and energy levels are present inside any component that has this label
attached. There are no serviceable parts inside these components. If you suspect a problem with
one of these parts, contact a service technician.
To install a power supply, do the following:
1. Press the tab 1 on the bezel that covers the bay of the power supply and insert a finger into the hole
in the middle of the bezel. Then, pull the bezel out to remove it.
.
Chapter 7 Installing, removing, or replacing hardware
2
77