Installing The Optical Drive - Lenovo ThinkServer RD240 Hardware Maintenance Manual

Figure 15. Removing the two retaining screws that secure the optical drive in the cage
8. If you are instructed to return the removed optical drive, follow all packaging instructions and use any
packaging materials that are supplied to you for shipping.
9. To complete the removal procedure, go to Completing the parts replacement.

Installing the optical drive

Attention: Do not open your server or attempt any repair before reading and understanding the "Safety information"
on page iii and "Guidelines" on page 35.
This section provides instructions on how to install the optical drive.
Important: Before you install optional hardware devices, make sure that the server is working correctly. If
the server is not working correctly, refer toDiagnostics for your server for detailed diagnostic information. To
obtain the publication, go to:
http://www.lenovo.com/support
To install the optical drive, do the following:
1. If you are replacing the optical drive, make sure that:
• You have all the cables and other equipment that is specified in the documentation that comes
with the new optical drive.
• You have checked the instructions that come with the new optical drive to determine whether you
must set any switches or jumpers in the drive.
Note: If you are installing a drive that contains a laser, observe the following safety precautions.
44
ThinkServer RD240 Hardware Maintenance Manual