Lenovo ThinkServer RD240 Hardware Maintenance Manual page 54

1. Remove all media from the drives and turn off all attached devices and the server. Then, disconnect all
power cords from electrical outlets and disconnect all cables that are connected to the server.
2. Remove the server cover. See Removing the server cover.
3. There is one screw on each side and two screws on the top. Remove the four screws that secure the
drive access panel (
Figure 12. Removing the drive access panel
4. Disconnect the power cable and the signal cable from the rear of the optical drive.
5. Remove the retaining screw on the rear bracket of the optical drive.
42
ThinkServer RD240 Hardware Maintenance Manual
1 ). Slide the drive access panel back and lift it to remove it ( 2 ).