Removing Or Installing The Heat Sink - Lenovo ThinkServer RD240 Hardware Maintenance Manual

Figure 53. Removing the bay bezel for the power supply
2. Slide the power supply into the chassis until it snaps into position.
Figure 54. Installing the power supply
3. To complete the installation, go to Completing the parts replacement.

Removing or installing the heat sink

This section provides instructions on how to remove or install the heat sink.
Removing the heat sink
Attention: Do not open your server or attempt any repair before reading and understanding the "Safety information"
on page iii and "Guidelines" on page 35.
This section provides instructions on how to remove the heat sink.
CAUTION:
The heat sink might be very hot. Turn off the server and wait three to five minutes to let the
server cool before removing the server cover.
To remove the heat sink, do the following:
78
ThinkServer RD240 Hardware Maintenance Manual