When Performing The Scanning Operation At Your Computer - Kyocera KM-2550 Operation Manual

When performing the scanning operation at your computer

1 Run the TWAIN Source in the corresponding application. The main dialogue box for the TWAIN
Source will appear. Make any settings that you want, and put a check mark in the [Waiting Scan]
checkbox.
2 Click on the [Connect] button in the main dialogue box and, once the connection to the scanner is
made, click on the [Scan] button.
Note
Putting a check mark in the [Waiting Scan] checkbox will allow you to start the actual scanning
operation by pressing the Start key at the scanner.
3 Set the original that you want to scan in the scanner
and press the Start key. Scanning will begin.
Notes
•
•
Scan settings can also be made on the operation panel of the scanner. Change any settings
there that you want.
If you enter different settings in your computer and in the scanner, the settings made on the
operation panel of the scanner will take priority.
Performing the Required Operation at the Scanner
3-5