Problem No. 2; Solution No. 2; Unix Problems - 3Com 3CRWPS10075-US - OfficeConnect Wireless 54Mbps 11g Print Server User Manual

Unix Problems

Problem No. 1
Solution No. 1

Problem No. 2

Solution No. 2

Print Server device is not recognized.
Check the following:
The network cable is OK.
■
There are no routers between the Print Server and the UNIX host
■
during IP address assignment.
There are no NetWare File Servers without TCP/IP support between the
■
Print Server and the UNIX host.
You have used the correct hardware address, as shown on a sticker on
■
the base of the device.
Use the ping command to see if the Print Server is a valid device on
■
the network.
The Print Server's IP address is forgotten and it needs to be installed in a
new environment.
Use the Reset button to restore the factory default settings, as described
below, then configure as for a new device.
1 Power down the Print Server OFF.
2 Press and hold the diagnostic button. While pressing the button, power
up the Print Server.
3 If you continue pressing the button for 10 seconds, a diagnostic page will
be printed, showing the new (default) settings.
Unix Problems 67