Wireless Configuration - 3Com 3CRWPS10075-US - OfficeConnect Wireless 54Mbps 11g Print Server User Manual

6 Click Next to configure the TCP/IP Screen:
■
■
7 On the Wireless Screens, the settings should be set to match your other
Wireless Stations. For details about each setting, refer to the following
section
8 Click Finish to save the data to the Print Server.
To install the Wizard on your PC, use the Install 3Com Print Server Utilities
option.
If the desired Print Server is not listed
■
■
■
■
Wireless Wireless Mode
Configuration
The Print Server is a Wireless station, NOT an access point. Like other
Wireless stations, they have 2 modes:
■
■
To use both the LAN and Wireless interfaces, the Wireless mode must be
set to "Ad-hoc". In "Infrastructure" mode, connecting a LAN cable will
disable the Wireless interface.
3Com recommends that you select Fixed IP Address.
For Fixed IP Address, enter an unused address from the range used on
your LAN, or click Suggest New Values.
Use the same Network Mask and Gateway as PCs on your LAN.
"Wireless Configuration".
Check all cables to the Print Server.
Check that the Print Server's Error LED is Off. If it is On, restart the
Print Server.
Check that your PC and the Print Server are on the same LAN subnet.
(If you do not have a Router or Gateway on your LAN, you only have 1
subnet.)
Check that your PC has either the TCP/IP or NetBEUI network
protocols installed. See
Ad-Hoc - no Access Point is used, Wireless stations communicate
directly with each other. Each Wireless station should be set to use the
same Channel, although some Wireless stations will scan all channels
to find compatible ad-hoc groups they can join
Infrastructure (Default) - all Wireless stations connect to the Access
Point. This allows connection to both other Wireless stations and the
wired LAN.
Using the Windows Wizard
Chapter 4 for details.
23