Led Indicators; Diagnostic Push Button - 3Com 3CRWPS10075-US - OfficeConnect Wireless 54Mbps 11g Print Server User Manual

16 C 1: I
HAPTER NTRODUCTION

LED Indicators

Diagnostic Push
Button
There are two (2) LED indicators on the top panel - Status (Green, right)
and Error (Red, left). The LED indicator modes are described in the
following table.
Table 3 LED Indicator Modes
Status LED Error LED
Off Off
On On
On Off
Blinking Off
Blinking Blinking
The Print Server is fitted with a Diagnostic Push Button. The button is
recessed; a pin or paper clip can be used to press it. This button has 2
functions:
Restore the factory default settings
■
Print a test page containing all current settings.
■
To restore the factory default settings:
1 Power down the the Print Server.
2 Press and hold the diagnostic button. While pressing the button, switch
the Print Server ON.
3 If you continue pressing the button for 10 seconds, a diagnostic page will
be printed, showing the new (default) settings.
To generate a Diagnostic print out
1 Ensure that both the Print Server and the printer are ON.
2 Press the diagnostic button, and hold it in for 2 seconds.
3 The test page, containing the current settings, will be printed.
PostScript printers are unable to print this page. If you have a PostScript
printer, the test page will not be printed.
Status Description
No Power
Hardware error
Normal operation (idle)
Normal operation - data is being transmitted or
received on the USB Printer Port.
During a Firmware Upgrade, both LEDs will blink.