Memory Control Change Out - Yamaha Programmable Mixer 01 User Manual

1. Press [MIDI].
The MIDI menu appears.
2. Select MEMORY CONTROL
CHANGE OUT and press
[ENTER].
The MEMORY CONTROL
CHANGE OUT LCD function
appears.
3. Use the cursor buttons to
select parameters and the
PARAMETER wheel and
[ENTER] button to set them.
4. Select OUTPUT:EXECUTE
and press [ENTER].
The selected data is output
and the message "EXECUT-
ING" appears. The message
changes to "....DONE" when
finished.
5. To exit this function and
return to the MIDI menu,
select EXIT and press
[ENTER], or just press
[MIDI].
The MIDI menu reappears.
!
Make sure that Control Tx is
set to ON before trying to output
mix scene data. Go to the MIDI
SETUP LCD function.

Memory Control Change Out

The MEMORY CONTROL CHANGE OUT LCD function allows you
to selectively output mix scene data as MIDI Control Change mes-
sages. This can be used to selectively update mix scene data on another
ProMix 01 or a controlling computer.
Shown below is the MEMORY CONTROL CHANGE OUT LCD
function.
OUTPUT: EXECUTE — this executes Control Change Out.
The following data types can be selected:
This selects the mix scene whose data is output. You can also select the
MEMORY
Edit Buffer (i.e. current mix settings).
CH1–16, ST IN, RTN1, RTN2, SEND3, SEND4, ST OUT ON/OFF
ON/OFF
(# 22–43).
LEVEL CH1–16, ST IN, RTN1, RTN2, SEND3, SEND4, ST OUT level (#0–21).
CH1–16, ST IN, RTN1, RTN2, ST OUT EQ ON/OFF (#196–215).
EQ
CH1–16, ST IN, RTN1, RTN2, ST OUT EQ F/G/Q (#216–395).
COMP1–3 ON/OFF (#458–460).
COMP1–3 # (#446–448).
COMP1–3 PATCH Channel (#449–451).
COMP
COMP1–3 KEYIN Channel (#452–454).
COMP1–3 KEYIN Mode (#455–457).
COMP1–3 Parameter 1–(5) (#461–475). The number of parameters
depends on the program selected.
CH1–16, ST IN L-R, RTN1 L-R, RTN2 L-R, SEND3, SEND4, ST OUT Pan,
Balance (# 44–67).
PAN
CH1–16, ST IN SEND3-4 Pan, Balance (# 140–156).
SEND1, SEND2, SEND3, SEND4 Pre/Post (# 136–139).
SEND
CH1–16, ST IN, SEND1, SEND2, SEND3, SEND4 Level (# 68–135).
Effect1, Effect2 Type (# 404–405).
EFFECT
Effect1, Effect2 Parameter 1–(10) (# 406–445). The number of param-
eters depends on the program selected.
CH1–16, ST IN Phase Normal/Reverse (# 179–195).
OTHERS
CH1–16, ST IN Group (# 484–500).
The following data is output with each of the above data types: CH1–16 Stereo Pair
Flag (# 396–406) and SEND3, 4 Configuration Flag (# 476).
Memory Control Change Out
ProMix 01 User's Guide
87