Turning Off A Daily Or Weekly Alarm; Message And Pager Indicators; Belt Clip; Removing The Belt Clip - Motorola LS350 User Manual

Turning Off a Daily or Weekly Alarm

From the Standby screen, press
m 84 f hjlbe
SET ALARM Press and release
displayed, then press
Press and release
m 84 f hjlbe
displayed, then press
OFF
The
momentarily.
Memory Full
When the pager memory is full, for example, all message locations are
occupied, MEM FULL is displayed in the Standby screen until a button is
pressed. When this occurs, delete your old unwanted messages to make
MEM FULL
room for newer messages.
message into the message folder when there is not enough storage space
left.
Note: If you don't delete any old messages, the pager automatically
deletes the oldest read message to make room for the new
message.
Low Battery
When the voltage of the pager's battery drops below a certain level,
displayed on all screens, even when the pager is off. The low-battery
condition is displayed until the battery is replaced.
Note: Check your pager's clock time after replacing the battery.
t
twice.
r
until SET ALARM is
s
twice.
r
until OFF is
s
.
TIME
screen is displayed
27
is also displayed if you try to move a
b
is
29
Connect Function
The menu selection CONNECT is intended for use by service personnel only.
When selected, an alternating pattern of
screen, press any button twice and the pager restarts.

Message and Pager Indicators

Your pager has several indicators to inform you of the status of your
messages and your pager.
Duplicate Message
When a new message is received that is identical to one already stored,
the older message is overwritten by the new one.
before the new message and new time stamp.
Errored Data
When a message is received that might contain errors, the characters likely
to be in error flash when the message is read.
Alarm
l
The alarm icon is displayed when the alarm is set and flashes during the
alarm alert.
28

Belt Clip

Your pager has a removable belt clip. To remove and replace the belt clip,
follow the instructions below.

Removing the Belt Clip

Insert the pointed end of a non-metallic
item (such as a pen cap) into the top
end of the belt clip as shown in the
illustration.
Push down on the tab and slide belt clip
forward to separate it from the pager.
Replacing the Belt Clip
Align the belt clip with the belt clip holder.
Slide the belt clip into the holder until it snaps back into place.
30
C C
C C
is displayed. To exit this
DUPLICATE
is displayed
Push down on tab
to release
belt clip