Indicators; Turning Off A Daily Or Weekly Alarm - Motorola LS350 User Manual

Press
m 81 f hjlbe
SET
SET
At the alarm time, your pager alerts,
ALARM 1
flashes. Press any button to remove the
alarm indication.
Note: If the alarm is set for Weekly or Daily,
the

Turning Off a Daily or Weekly Alarm

From the Standby screen, press
m 84 f hjlbe
Press and release
SET ALARM
displayed, then press
Press and release
m 84 f hjlbe
then press
OFF
The
Memory Full
When the pager memory is full, for example, all message locations are occupied,
is displayed in the Standby screen until a button is pressed. When this occurs,
FULL
delete your old unwanted messages to make room for newer messages.
also displayed if you try to move a message into the message folder when there is not
enough storage space left.
Note: If you don't delete any old messages, the pager automatically deletes the
oldest read message to make room for the new message.
Low Battery
When the voltage of the pager's battery drops below a certain level,
on all screens, even when the pager is off. The low-battery condition is displayed until
the battery is replaced.
Note: Check your pager's clock time after replacing the battery.
s
.
is displayed momentarily.
is displayed, and the indicator
l
indicator stays on the display.
l
t
twice.
r
until is
SET ALARM
s
twice.
r
until OFF is displayed,
s
.
TIME screen is displayed momentarily.
MEM
MEM FULL
is displayed
b
Connect Function
The menu selection
CONNECT
selected, an alternating pattern of
button twice and the pager restarts.
Message and Pager Indicators
Your pager has several indicators to inform you of the status of your messages and
your pager.
Duplicate Message
When a new message is received that is identical to one already stored, the older
message is overwritten by the new one.
message and new time stamp.
Errored Data
When a message is received that might contain errors, the characters likely to be in
error flash when the message is read.
Alarm
The alarm icon is displayed when the alarm is set and flashes during the alarm
l
alert.
58
57
Belt Clip
Your pager has a removable belt clip. To remove and replace the belt clip, follow the
instructions below.
is
Removing the Belt Clip
Insert the pointed end of a non-metallic
item (such as a pen cap) into the top
end of the belt clip as shown in the
illustration.
Push down on the tab and slide belt clip
forward to separate it from the pager.
Replacing the Belt Clip
Align the belt clip with the belt clip holder.
Slide the belt clip into the holder until it snaps back into place.
Cleaning Your Pager
To clean smudges and grime from the exterior of your pager, use a soft, non-abrasive
cloth moistened in a mild soap and water solution. Use a second cloth moistened in
clean water to wipe the surface clean. Do not immerse in water. Do not use alcohol or
other cleaning solutions.
60
59
is intended for use by service personnel only. When
cC Cc
is displayed. To exit this screen, press any
is displayed before the new
DUPLICATE
Push down on tab
to release
belt clip