Motorola LS355 User Manual

Motorola LS355 User Guide
Battery Information
Your pager is designed to operate with a single AA-size alkaline battery.
Always ensure that polarity (+ and -) markings on battery match diagram beside the
battery compartment when changing the battery.
Caution: Do not insert the battery backwards or the messages stored in memory will be
erased.
Installing or replacing battery
1. Turn the pager off.
2. Unlock the battery door lock be sliding the door latch away from the battery door.
3. Slide the battery door in the direction of the arrow (toward the outer edge).
4. Lift the outer edge of the battery door to open. Remove battery.
5. To install a new battery, reverse this procedure, taking note of the positive (+) and
negative (-) markings.
Turning Your Pager On/Off
1. Ensure battery is installed.
2. Slide the button to N or M position to turn your pager on. The pager performs its self-
test by emitting one short beep, lighting the red LED, displaying all icons and
numbers, vibrating, and illuminating its backlight for 2 seconds. The pager then
displays LS355 and the speaker icon for 4 seconds, indicating that it is ready to
receive messages. The pager then displays the time and date, indicating that it is in
standby mode.
To turn your pager off
Slide the button to the &bull (off) position. The pager display turns off.
Setting Alert Mode
1. Slide the button to the N (normal) position to select Alert Mode. When switched to
Alert Mode, the pager sounds a beep tone for 2 seconds, and the speaker icon is
displayed. You can choose a beep or one of six melodies as the alert tone.
2. Push and hold the button until the pager displays: SET TONE
3. Release the button, then push it again. The beep alert sounds and the pager displays:
BEEP
4. When you push the button again, the first of 6 melody alerts activates and the pager
displays: MUSIC 1
5. When you push the button again, the second melody alert activates and the pager
displays: MUSIC 2
6. Continue pressing the button until you hear a melody you want to use as the alert tone.
7. When you have selected the desired tone or melody, return the pager to standby mode
by either holding the button for 2 seconds, or allowing the pager to time out for 8
seconds.