Table of Contents
Advertisement
Setting the O.T.T. timer
Timer playback which occurs only once and only for an hour can be programmed by simply setting the start
time. The timer playback reproduces the source selected at the last time the unit is turned off at the last set
volume.
It is not recommended to play a DVD VIDEO or VCD disc using the timer function, for expected playback may
sometimes unavailable with these discs.
Adjust the clock before setting the timer %
1
Select the desired source.
2
Press the MODE key.
3
Turn the VOLUME/MULTI CONTROL knob
to select "TIMER SET", then press the SET/
DEMO key.
VOLUME/
MULTI CONTROL
4
Turn the VOLUME/MULTI CONTROL knob
to select "O.T.T. SET ?", then press the SET/
DEMO key.
5
Set the timer ON time by turning the VOL-
UME/MULTI CONTROL knob.
VOLUME/
MULTI CONTROL
The time is
returned
6
Press the SET/ DEMO key.
7
Turn the VOLUME/MULTI CONTROL knob
to select "ON", then press the SET/ DEMO
key.
8
Adjust the volume.
9
Press the
key to switch the power OFF
(standby).
(When the unit enters the Standby mode, the
STANDBY/TIMER indicator lights in amber.)
After setting the timer, make sure that the power is
set to OFF (Standby).
MODE
SET/DEMO
\
The time is
advanced
The program timer does not operate during playback
by the O.T.T. timer.
T I M
E
÷ When a timer setting has already been made in the se-
lected timer, the setting will be overwritten by the new
setting.
÷ If you make a mistake, press the MODE key and restart
from step 2.
÷ The ON time can be set in steps of 5 minutes.
O
. T
. T
÷ If there is a power failure or the power cord is un-
plugged after the timer reservation has been acti-
vated, the STANDBY/TIMER indicator blinks in am-
ber. In this case, the clock setting should be re-
started from the beginning.
To check or modify the reservation contents,
restart the timer reservation from the beginning.
Timer operation
R
S
E T
7 :
0
0
a
m
P
A
.
>
O
N
57
Advertisement
Table of Contents
