Balance Level; Fader Level; Non-Fading Level; High-Pass Filter Frequency For Front Output - Kenwood KDC-PS9018R Instruction Manual

Balance Level

Adjust the balance level.
Display and setting:
"Balance" : Left 15 – Right 15

Fader Level

Adjust the fader level.
Display and setting:
"Fader" : Rear 15 – Front 15

Non-Fading Level

Adjust the Non-fading output level.
Display and setting:
"NF Level" : - 15 – + 15
NOTE
• This mode is available only when the non-fading output function
is set to on.
• Not available during the Dual zone system is on.

High-pass Filter Frequency for Front Output

Adjust the frequency of the High-pass filter for front output.
Display and setting:
"HPF Front" : Through / 40Hz / 60Hz / 80Hz / 100Hz / 120Hz /
150Hz / 180Hz / 220Hz
NOTE
You can separately set the high-pass filter for front and rear
output, including preouts. The high-pass filter does not affect the
non-fading preout.

High-pass Filter Frequency for Rear Output

Adjust the frequency of the High-pass filter for rear output.
Display and setting:
"HPF Rear" : Through / 40Hz / 60Hz / 80Hz / 100Hz / 120Hz /
150Hz / 180Hz / 220Hz
NOTE
You can separately set the high-pass filter for front and rear
output, including preouts. The high-pass filter does not affect the
non-fading preout.

Low-pass Filter Frequency for Non-Fading Output

Adjust the frequency of the Low-pass filter for Non-Fading
output.
Display and setting:
"LPF NF" : 50 Hz / 80 Hz / 120 Hz / Through
NOTE
• This mode is available only when the non-fading output function
is set to on.
• Not available during the Dual zone system is on.

Phase for Non-Fading Output

Adjust the phase for Non-Fading output.
Display and setting:
"NF Phase" : Normal (0°) / Reverse (180°)
NOTE
• This mode is available only when the non-fading output function
is set to on.
• Not available during the Dual zone system is on.
— 17 —