Table of Contents
Advertisement
Installation (non-Japanese cars)
■
Installation (non-Japanese cars)
Firewall or metal support
Accessory4
Phillips truss
Accessory2
head sheet
Metal mounting
metal screw
strap
(commercially
available)
NOTE
Make sure that the unit is installed securely in place. If the unit
is unstable, it may malfunction (for example, the sound may
skip).
2CAUTION
To attach this unit, make sure the front of the control panel faces
you and fit it into the mounting sleeve by pressing the four corners
of the hard rubber frame at the same time.
Do not apply strong pressure to other sections than the corners;
otherwise troubles such as the impossibility of opening or closing
the panel may result.
Locking the faceplate to the unit
■
Locking the faceplate to the unit
If you want to lock the faceplate to the unit so that it does not
fall off, follow the directions below.
1
Refer to the function "Removing the faceplate (page 12)" and
remove the faceplate.
2
Insert the provided screw into the hole at the center of the
bottom side of the faceplate which you have removed from
the unit.
Bend the tabs of the
mounting sleeve with
a screwdriver or similar
utensil and attach it in
3
Refer to the section "Removing the faceplate (page 12)" and
place.
then reattaching the faceplate.
2CAUTION
Never insert the taptite screws (ø2 × 4 mm) in any other screw
holes than the one specified. If you insert it in another hole, it
will contract and may cause damage to the mechanical parts
inside the unit.
— 44 —
Accessory7
Advertisement
Table of Contents
