Firmware Upgrade Parameters - Linksys SPA2102-AU Provisioning Manual

Chapter 4 Provisioning Field Reference

Firmware Upgrade Parameters

The following table defines the function and usage of each parameter in the Firmware Upgrade section
of the Provisioning tab.
Table 4-2
Parameter Name
Upgrade_Enable
Upgrade_Error_Retry_Delay
Downgrade_Rev_Limit
Upgrade_Rule
Log_Upgrade_Request_Msg
Log_Upgrade_Success_Msg
Log_Upgrade_Failure_Msg
License Keys
Version 3.0
Firmware Upgrade Parameters
Firmware Upgrade Parameters
Description and Default Value
Enables firmware upgrade operations
independently of resync actions.
The default is Yes.
The upgrade retry interval (in seconds) applied in
case of upgrade failure. The device has a
firmware upgrade error timer that activates after
a failed firmware upgrade attempt. The timer is
initialized with the value in this parameter. The
next firmware upgrade attempt occurs when this
timer counts down to zero.
The default is 3600 seconds.
Enforces a lower limit on the acceptable version
number during a firmware upgrade or
downgrade. The device does not complete a
firmware upgrade operation unless the firmware
version is greater than or equal to this parameter.
The default is (empty).
This parameter is a firmware upgrade script with
the same syntax as Profile_Rule. Defines
upgrade conditions and associated firmware
URLs.
The default is (empty).
Syslog message issued at the start of a firmware
upgrade attempt.
The default is $PN $MAC -- Requesting upgrade
$SCHEME://$SERVIP:$PORT$PATH.
Syslog message issued after a firmware upgrade
attempt completes successfully.
The default is $PN $MAC -- Successful upgrade
$SCHEME://$SERVIP:$PORT$PATH -- $ERR.
Syslog message issued after a failed firmware
upgrade attempt.
The default is $PN $MAC -- Upgrade failed:
$ERR.
This field is empty.
Linksys SPA Provisioning Guide
4-5