Linksys SPA2102-AU Provisioning Manual page 64

Configuration Profile Parameters
Table 4-1
Parameter Name
Resync_Random_Delay
Resync_Periodic
Resync_Error_Retry_Delay
Linksys SPA Provisioning Guide
4-2
Configuration Profile Parameters (continued)
Chapter 4
Description and Default Value
The maximum value for a random time interval
that the device waits before making its initial
contact with the provisioning server. This delay
is effective only on the initial configuration
attempt following device power-on or reset. The
delay is a pseudo-random number between zero
and this value.
This parameter is in units of 20 seconds; the
default value of 2 represents 40 seconds. This
feature is disabled when this parameter is set to
zero.
This feature can be used to prevent an overload
of the provisioning server when a large number
of devices power-on simultaneously.
The default is 2 (40 seconds).
The time interval between periodic resyncs with
the provisioning server. The associated resync
timer is active only after the first successful sync
with the server.
Set this parameter to zero to disable periodic
resyncing.
The default is 3600 seconds.
Resync retry interval (in seconds) applied in case
of resync failure.
The device has an error retry timer that activates
if the previous attempt to sync with the
provisioning server fails. The device waits to
contact the server again until the timer counts
down to zero.
This parameter is the value that is initially loaded
into the error retry timer. If this parameter is set
to zero, the device immediately retries to sync
with the provisioning server following a failed
attempt.
The default is 3600 seconds.
Provisioning Field Reference
Version 3.0