Dell PowerEdge KVM 1081AD User Manual page 29

3 Line up the screw holes in the bracket with the screw holes in the switch.
4 With a Phillips screwdriver, fasten the front mounting brackets to the
switch using two screws on each side.
5 Attach four cage nuts or clip nuts to the rack mounting flange of the
rack cabinet's front so that the nut is positioned on the inside of the
rack.
6 Mount the switch assembly to the rack cabinet by matching the holes in
the "short side" of each bracket to an appropriate set of matching holes
on your rack cabinet. Next, insert the combination hex head screws
through the slots in the bracket, then the holes in the mounting rail, and
then into the cage nuts or clip nuts.
7 Attach four cage nuts or clip nuts to the rack mounting flange of the
rack cabinet back so that the nut is positioned on the inside of the rack.
8 Slide the rear brackets into the channel of the front brackets adjusting
them to fit the rack depth.
9 Mount the rear bracket to the rack cabinet by matching the holes in the
"short side" of each bracket to an appropriate set of matching holes on
your rack cabinet, ensuring the switch is level within the rack.
10 Insert the combination hex head screws through the slots in the bracket
and the holes in the mounting rail, then into the cage nuts or clip nuts.
Installation
13