Getting Into Programming Mode; Programming Your Device With Code Set - RCA RCU810 - Learning Universal Remote Control User Manual

RCU810_MANUAL.QXD 1/7/02

Getting Into Programming Mode

ENTERING PROGRAM MODE
1. Press and hold the CODE SEARCH key for at least
3 seconds until a CODE SET display message is
seen on the LCD display window.
2. One menu message will be shown one at a time, for
Menu 1 through 13.
In order to access all 13 programming items shown below,
special key press cycle must be performed to get into this
mode (See page 21).
3. Use UP ( ) key DOWN ( ) key to scroll up or scroll
down the menu messages to have the desired
message appeared in the display message window.
4. Press SELECT to select a desired programming
mode.

Programming Your Device With Code Set

1. Manually turn on the device you want to program.
2. Press and hold the CODE SEARCH key until the
remote window displays CODE SET.
3. Press the SELECT key to enter into the CODE SET sequence.
4. Use the Device or UP ( ) key DOWN ( ) key to scroll
to the desired device.
(TV, VCR, TAPE, LDP, DAT, DVD, CD, TUNER, AMP, HOME,
MISC, PHONO, CAB, SAT & VIDEO)
5. After the desired device type is selected, find the four-
digit code for the corresponding device in the code lists
starting at page 9. Enter the four-digit number for the
desired setup code.
6. Once the four-digit code has been entered press the
SELECT key to accept the desired setup ID code. The
LCD display window will show a message displaying
SUCCESS or NOT FOUND to verify the ID code.
NOTE: If the message displays NOT FOUND return to step 5
and repeat the steps again.
7. To exit the SETUP CODE, press CLEAR key. EXIT
SETUP will be displayed and the remote exits code
setup programming.
8. With your device on , press the CH+ (Channel Up). Some
devices may not respond to CH+. For those devices
press the ON•OFF key. If the device responds, no further
programming is required.
NOTES:
• Press the CLEAR key at any time to exit the programming
mode. An EXIT SETUP message will appear confirming that
no new codes have been entered.
5
11:49 AM Page 6
.
OR
OR
OR