Deleting A Macro Key Sequence - RCA RCU810 - Learning Universal Remote Control User Manual

RCU810_MANUAL.QXD 1/7/02

Deleting A Macro Key Sequence

To delete a Macro key sequence, either overwrite it with a new key on the same key, or use the
procedure below.
1. Press and hold the CODE SEARCH key until the remote
window displays CODE SET.
2. Step through the programming menu using the
UP ( ) key or DOWN ( ) key for KEY MACRO,
then press the SELECT key.
3. Once the SELECT key is pressed a SEL MACKEY
message will display for you to input a Macro Key.
NOTE: If the entered key is a invalid Macro Key, a display
message INVALID will be shown and the remote will
stay in Macro programming mode until a valid Macro
Key is entered.
4. Press the Macro Key (M1, M2 or M3) to enter into the
correct sequence. The display message ENTER SEQ
will be shown.
5. Press and hold down the SELECT key for 3 seconds to
complete the deleting sequence. The SELECT key must
be pressed and held down for at least 3 seconds to
exit the sequence.
6. The remote will then display the message SUCCESS,
followed by the message EXIT SETUP and return to its
normal operation.
NOTES:
• Press the CLEAR key at any time to exit the programming
mode. An EXIT SETUP message will appear and the remote
will return to its normal operation.
• If about 30 seconds passes before a key is pressed, the LCD
display window will stop transmission to conserve battery life.
If this occurs, restart from step 1.
11:49 AM Page 19
Hold For 3 Seconds
18