Reassigning The Audio•Aux Or Dvd•Vcr Key; Volume Punch-Through - RCA RCRPS04GR Owner's Manual

To enable Master Power again:
1. Press and hold the P key for 3 seconds. The
POWER key comes on.
2. Press VOL+ to enable Master Power again.
3. Press the P key to confi rm. The Master Power
function is enabled again.
Reassigning the AUDIO•AUX
or DVD•VCR Key
The AUDIO•AUX key defaults to control an audio
receiver, and the DVD•VCR key defaults to control
a DVD player. If you want the AUDIO•AUX or
DVD•VCR key to control a different device (an
additional TV, DVD, satellite or cable box, for
example), you must reassign it.
1. Press and hold the AUDIO•AUX or DVD•VCR
key. The POWER key turns on.
2. While holding down the AUDIO•AUX or
DVD•VCR key, press and release the number
key on the keypad for the device you wish to
control (see the chart below). The POWER key
turns off.
AUDIO•AUX OR DVD•VCR KEY CONTROLS:
Additional TV
VCR or DVR
Additional DVD
Additional audio device
Additional satellite receiver, cable box,
or DTV converter
3. Release the AUDIO•AUX or DVD•VCR key. The
POWER key blinks four times and then turns
off. The AUDIO•AUX or DVD•VCR key is now
set to control the device type you selected.
4. Follow the directions in the auto, brand, direct
entry, or manual code search to program the
AUDIO•AUX or DVD•VCR key.

Volume Punch-Through

Volume Punch-Through allows the VOL and
MUTE keys, when pressed in SAT•CBL•STREAM
or DVD•VCR modes, to "punch through" to either
TV or AUDIO•AUX, whichever was accessed last.
Volume Punch-Through occurs automatically and
allows you to control the volume without exiting
the current mode. (If the DVD•VCR key has been
programmed with a TV or AUDIO code, volume can
punch through to this device as well.)
Note: Volume Punch-Through does not occur
in cases where the component code has its own
volume/mute controls, such as some satellite
receivers.
press 1
press 2
press 3
press 4
press 5
17