8.10.4 CF_CEIL COMMAND
"CF_CEIL_%1"[CR]
COMMAND
"ON"------ Select Ceiling
%1
"OFF"---- Cancel Ceiling
Set/Cancel Ceiling (Only valid when it is in the usual Power On state.)
Details
The value set is stored in EEPROM. When ALL OFF the projector, the
value will return to the original setting.
Acceptable
Response
Unacceptable
8.10.5 CF_REAR COMMAND
"CF_REAR_%1"[CR]
COMMAND
"ON"------ Select Rear
%1
"OFF"---- Cancel Rear
Set/Cancel Rear (Only valid when it is in the usual Power On state.)
When Rear is ON, it will be a mirror-reversed image.
Details
The value set is stored in EEPROM. When ALL OFF the projector, the
value will return to the original setting.
Acceptable
Response
Unacceptable
8.10.6 CF_RCODE COMMAND
"CF_RCODE_%1"[CR]
COMMAND
"001"------Select Code1
%1
"002"------Select Code2
Select a remote control code.(Only valid when it is in the usual Power On
state.)
Details
The value set is stored in EEPROM. When ALL OFF the projector, the
value will return to the original setting.
Acceptable
Response
Unacceptable
"000"[CR]
"Error Code"[CR]
"000"[CR]
"Error Code"[CR]
"000"[CR]
"Error Code"[CR]
Page
33 / 53