Error Messages - Kyocera FS-2020D Operation Manual

Message
Account error ##
Press GO
Add paper MPTray
Call service
F###:
Call service
### :0123456
#
Canceling data
Cassette #
not loaded
Change envelope
switch position
Check
cassette #
Check waste
toner box
Clean printer
Press GO
Close
left cover
Troubleshooting

Error Messages

The following table lists errors and maintenance messages that you can
be dealt with by yourself.
If Call service or Error.Power off. is displayed, turn off the
printer then turn it back on to see if the printer has recovered. If the
printer has not recovered, turn off the printer, disconnect the power cord,
and contact your service representative or authorized service center.
Some errors cause the alarm to sound. To stop the alarm, press
[Cancel].
Corrective Action
This message is displayed when the Job Accounting function is enabled and an attempt to
specify job accounting settings or to register or delete an account fails. To return the printer to
the print-ready status, press [GO].
The paper has run out in the paper source displayed. Supply paper according to the paper
source displayed (paper cassettes, MP tray, or optional paper feeders).This message is
displayed alternately with messages indicating the printer status, such as, Ready, Please
wait, and Processing.
F### represents a controller error (#=0, 1, 2, ...). Call for service. The printer does not
operate when this message is displayed.
#### represents a mechanical error (#=0, 1, 2, ...). Call for service. The printer does not
operate when this message is displayed. The total number of pages printed is also indicated,
e.g. 0123456.
Displayed when data is being canceled.
The corresponding paper cassette is not installed. Install the cassette. The cassette number
can be 1 (topmost) to 4 (bottom).
Displayed when the paper type does not match the envelope switch setting.
This message is displayed when a paper lift error has occurred in the paper source's
cassette. Pull out the cassette for the paper source displayed (either the paper cassettes or
optional paper feeders) and check if the paper is loaded correctly.
The message Call service is displayed when this error occurs repeatedly.
This message warns following two cases. Install the new waste toner box.
The waste toner box is not installed.
The waste toner box is full.
Please clean the inside of the printer. Refer to Cleaning the Printer on page 4-7.
This message will be displayed when replacing the toner container after the message
Replace toner Clean printer is displayed. After cleaning the inside of the printer,
press [GO] and the printer will be ready for printing.
The left cover of the printer is open. Close the printer left cover.
5-5