Error Messages - Kyocera PA2001w Operation Manual

Error Messages

If a problem has occurred in the printer, the indicators on the operation panel, the KYOCERA Client Tool, and the Status
Monitor will show the status of the printer. Problems that can be resolved by the user are described below.
Indicators
If the Attention indicator is lit or flashing, check the KYOCERA Client Tool.
Note If the indicators light or flash repeatedly in manners not described above, a service error has probably
occurred. Switch off the printer [Main Power] (
switch on [Main Power] (
Message Displayed in KYOCERA
Client Tool and Status Monitor*
Add paper
Add toner
Cover open
Error has occurred
Memory overflow
Paper jam
Toner is running out.
Top tray full
* Events for which the Status Monitor provides notification can be set in the Configuration. Refer to Configuration
on page 3-42.
), unplug the power cord, and then plug the power cord back in and
). This may clear the error. If the error is not cleared, contact your service technician.
Meaning
There is no paper in the paper source. Load paper into the paper source.
The paper size in the paper source is
different from the printer driver setting.
The toner has run out.
The top cover is open.
There is a condensation inside the
machine.
This message is displayed if the
installed toner cartridge's regional
specification does not match the
machine's.
Unable to continue the job as the
memory is used up.
A paper jam has occurred.
The toner is running out.
The top tray is full of paper.
7-8
Troubleshooting
Remedy
Load the proper size of paper in the
paper source.
Replace with a new toner cartridge.
Close the top cover.
Please wait for about an hour and then,
turn the power off and on. Refer to
Power On/Off on page 3-2.
Install the specified toner cartridge.
Change the print resolution from Fast
1200 to 600 dpi. Refer to Printer Driver
User Guide.
Refer to Clearing Paper Jams on
page 7-9 and remove the jammed paper.
Have a new toner cartridge ready.
The printer pauses after 50 sheets are
printed. Remove paper from the top tray
and press [Main Power] (
printing.
) to begin