Advertisement
Test Flash Procedure
Use the supplied programmer to flash the ECU and verify
its compatibility.
• Confirm that you have the latest calibration by checking
the Edelbrock website
(http://www.edelbrock.com/automotive_new/mc/
superchargers/software-tech.shtml ) and entering your
serial number in the search field.( Your 4 digit supercharger
serial number is written on your kit checklist paperwork,
and is also stamped on the front bolt bosses of your
supercharger-first 2 digits on RH bolt boss, 2nd 2 digits on
LH bolt boss.) Once you have found the latest tune on the
site, power on the programmer, press the left arrow and
select the Device Info option. Scroll down to Tune Version
and compare that number to the one on the site. If they are
different, download the new calibration as instructed on the
website.
• Put the car into Acc mode, but don't start the vehicle.
• Connect the supplied PCM cable to the OBD-II connector.
• Use directional pad to highlight Program Vehicle option
and press Select button.
• Use directional pad to highlight Preprogrammed Tune
option and press Select button.
• Read disclaimer then press Select to continue.
• Verify ignition is in the 'Key On' position but that the
engine is not running then press Select.
•
Use directional pad to highlight your vehicle and
transmission combination then press Select.
•
Use directional pad to highlight Begin Program then
press Select.
©2012 Edelbrock LLC
Part #1596, 1597, 1598, 1599
Edelbrock E-Force Supercharger System for
the 2010-2012 Camaro SS
Installation Instructions
•
Depending on your specific drivetrain configuration,
several separate operations may take place during this
step.Completion of each operation will cause the progress
bar to reset to zero.
DO NOT unplug the programmer until prompted.
• Turn the car off when prompted to do so by the handheld
programmer.
• Read parting message from programmer then press
Select to continue.
• Unplug the programmer cable from the OBD-II port.
In the rare occurrence that you encounter an error message
during the test flash procedure, please refer to pg. 27, titled
Email Edelbrock Your Stock PCM Calibration.
Post Successful Test Flash
If you are ready to install the supercharger, proceed to Step
1 of the Supercharger Installation
OR
If you wish to return the ECU back to the factory calibration,
such that the vehicle can still be driven until you are ready
to begin the installation, then:
• Put the car into Acc mode, but don't start the vehicle.
• Connect the supplied PCM cable to the OBD-II connector.
• Use directional pad to highlight Program Vehicle option
and press Select button.
Page 7
Brochure #63-1598
Rev. A - 2/12 - CP/mc
Advertisement
