Advertisement
8. Use a 10mm socket to remove the two bolts retaining
the bottom of the fascia.
9. Use a panel puller to remove the six body pins holding
the top of the fascia then use a 10mm socket to remove
the bolt at each end of the top of the fascia.
10. The front fascia can now be pulled forward and off
the car and set aside.
11. Disconnect the Mass Airflow Sensor connector.
12. Use a flat head screwdriver to loosen the worm clamp
holding the inlet tube to the air box lid then remove the air
box lid by pushing the lock tabs back.
13. Remove the oil fill cap and remove the plastic engine
cover. Reinstall the oil fill cap.
©2012 Edelbrock LLC
Part #1596, 1597, 1598, 1599
Edelbrock E-Force Supercharger System for
the 2010-2012 Camaro SS
Installation Instructions
14. Disconnect passenger side PCV tube from the valve
cover then use a flat head screwdriver to loosen the worm
clamp retaining the air intake tube to the throttle body.
Remove and discard the air intake tube and PCV hose.
15. Use a 15mm socket and a breaker bar to loosen the
tensioner and remove the serpentine belt.
16. Disconnect the Electronic Throttle Control connector
on the passenger side of the throttle
body.
17. Use a 10mm socket to remove the four bolts retaining
the throttle body and set it aside.
Page 9
Brochure #63-1598
Rev. A - 2/12 - CP/mc
Advertisement
