Advertisement
92. Install the M8 nuts and M8 x 20mm bolts supplied in
Bag #2 into the holes in the lower heat exchanger brackets
then use a 12mm wrench and socket to tighten them.
93. Install the intercooler water pump bracket on the
studs located on the back of the passenger side of the
bumper. Secure it in place with the M8 nuts supplied in
Bag #2 and tighten them with a 12mm wrench.
94. Install the water pump to heat exchanger hose on the
passenger side inlet fitting of the heat exchanger and
clock it until it contacts the lower radiator shroud. Secure
the fitting with a 3/4" hose clamp supplied in Bag #2.
95. Slide the strap over the body of the water pump and
install it in the water pump bracket. Rotate the water
pump and slide it in and out until it roughly lines up with
the position of the hose on the other side of the lower
radiator shroud.
©2012 Edelbrock LLC
Part #1596, 1597, 1598, 1599
Edelbrock E-Force Supercharger System for
the 2010-2012 Camaro SS
Installation Instructions
96. Use a uni-bit to drill a 1-1/8" hole in the lower
radiator shroud to allow the hose to slide onto the water
pump outlet fitting.
97. Use the supplied bolt and a 13mm socket to secure
the water pump by tightening the strap to the bracket.
98. Slide the hose onto the water pump outlet and secure
it with a 3/4" hose clamp supplied in Bag #2.
99. Install the Intercooler Hose Assembly by sliding it
down between the radiator fan assembly and the engine.
Note that the short hose section will go around the
radiator to the outlet of the heat exchanger.
100. Use a unibit to drill a 1-1/8" hole in the radiator
shroud on the driver side directly across from the heat
exchanger outlet.
Page 17
Brochure #63-1598
Rev. A - 2/12 - CP/mc
Advertisement
