Advertisement
18. Push down the white tab on the front EVAP hose
fittings and disconnect them from the manifold and the
EVAP solenoid.
19. Disconnect the Manifold Air Pressure sensor and
EVAP solenoid electrical connectors.
20. Use a 3/8" Fuel Line Removal Tool to disconnect the
fuel line from the fuel rails and from the passenger side
fender fitting. Use a shop rag to absorb any excess fuel.
21. Use a 10mm socket to remove the nut holding down
the fuel line clamp then remove the fuel line and clamp.
©2012 Edelbrock LLC
Part #1596, 1597, 1598, 1599
Edelbrock E-Force Supercharger System for
the 2010-2012 Camaro SS
Installation Instructions
22. Disconnect the two ignition harness connectors, the
eight spark plug wires from the ignition coils and the eight
fuel injector electrical connectors.
23. Use a 10mm deep socket to remove the five studs
retaining each of the ignition coil brackets to the valve
covers. Lift and remove the coil brackets as an assembly.
24. Disconnect the EVAP hose from the EVAP Solenoid
and the passenger side fender fitting.
25. Use a 10mm socket to remove the nut on the driver
side and remove the plastic manifold webbing.
Page 10
Brochure #63-1598
Rev. A - 2/12 - CP/mc
Advertisement
