Advertisement
104b. FOR 2012 MODEL YEAR ONLY Use a 10mm
wrench to install the standoff, supplied in Bag #2, to the
stud located on the back of the radiator fan. See Figure 3b
Figure - 3b
105. Install the intercooler reservoir - water pump hose
onto the outlet of the intercooler reservoir so that the
other end will extend down to the inlet of the intercooler
water pump. Secure the hose to the reservoir fitting with
a supplied hose clamp. See Figure 4
To passenger side manifold
To water pump
Figure 4
©2012 Edelbrock LLC
Part #1596, 1597, 1598, 1599
2012
To driver side manifold
Edelbrock E-Force Supercharger System for
the 2010-2012 Camaro SS
Installation Instructions
106. Lower the intercooler reservoir and its attached
hose down into the passenger side of the engine bay so
that the lower bracket will line up with the mounting hole
(Refer to the Figure that corresponds to your model
year;"3a" or "3b") , the upper bracket will line up with the
passenger side radiator fan assembly bolt and the hose
will mate up to the intercooler water pump.
107. Use a 13mm (10mm for 2012 Models) socket to
reinstall the stock radiator fan assembly bolt through the
upper reservoir bracket.
108a. FOR 2010 - '11 MODEL YEARS ONLY Secure the
lower intercooler reservoir bracket to the back of the fan
by using a 10mm socket to re-install the stock bolt onto
the standoff stud. (Refer to Figure "3a")
108b. FOR 2012 MODEL YEAR ONLY Secure the lower
intercooler reservoir bracket to the back of the fan by
using a 4mm allen to install the M5 X 10mm bolt, supplied
in bag 2, onto the spacer. (Refer to Figure"3b")
109. Secure the intercooler reservoir to water pump hose
to the inlet of the water pump with a supplied hose clamp.
Page 19
Brochure #63-1598
Rev. A - 2/12 - CP/mc
Advertisement
