Advertisement
162. Reinstall the front wheels and snug the lug nuts.
Lower the vehicle to the ground then torque the lug nuts
in a crossing pattern to 100 ft/lbs.
If you have yet to flash your ECU, then proceed with
steps 163 - 176, otherwise disregard them.
163. It is recommended that you check the Edelbrock
website (http://www.edelbrock.com/automotive_new/mc/
superchargers/fuel_injected_soft-tech.shtml) to confirm
that you have the latest calibration. Once you have found
the latest tune on the site, power on the programmer,
press the left arrow and select the Device Info option.
Scroll down to Tune Version and compare that number to
the one on the site. If they are different, download the new
calibration with the supplied USB cable.
164. Turn the key to the On position, but do not start it.
165. Connect the PCM cable from the supplied
downloader to the OBD-II connector located below the
steering wheel in the passenger compartment.
166. Use the directional pad to highlight the Program
Vehicle option and press the Select button.
167. Use the directional pad to highlight the
Preprogrammed Tune option and press the Select button.
168. Read disclaimer then press Select to continue.
169. Verify ignition is in the 'Key On' position but that the
engine is not running then press Select.
170. Use directional pad to highlight your vehicle and
transmission combination then press Select.
171. Use directional pad to highlight your vehicle and
transmission combination then press Select, again.
172. Use directional pad to highlight Begin Program then
press Select.
©2012 Edelbrock LLC
Part #1596, 1597, 1598, 1599
Edelbrock E-Force Supercharger System for
the 2010-2012 Camaro SS
Installation Instructions
173. Vehicles equipped with a manual transmission will
have three separate operations take place during this
step, while vehicles with an automatic transmission will
have five. Completion of each operation will cause the
progress bar to reset to zero.
DO NOT unplug the programmer until prompted.
174. Turn the car off when prompted to do so by the
handheld programmer.
175. Read parting message from programmer then press
Select to continue.
176. Unplug the programmer cable from the OBD-II port.
177. Start the car and allow it to idle while closely
inspecting the engine bay for any fuel or coolant leaks.
Repair any leaks before operating vehicle!
178. Remove the engine oil dipstick.
Page 25
Brochure #63-1598
Rev. A - 2/12 - CP/mc
Advertisement
