Advertisement
149. Use a 10mm socket to remove the passenger side
fender bolt, install the ground strap ring connector
underneath it then reinstall the bolt.
150. Disconnect the stock EVAP solenoid electrical
connector and plug it into the color matched receptacle on
the relay harness.
151. Clip the supplied EVAP solenoid electrical connector
on the relay harness into the EVAP solenoid.
152. Carefully route the Passenger Side PCV Hose to the
fitting on the underside of the silicone air inlet tube so as
to avoid contact with the serpentine belt or any pulleys.
©2012 Edelbrock LLC
Part #1596, 1597, 1598, 1599
Edelbrock E-Force Supercharger System for
the 2010-2012 Camaro SS
Installation Instructions
153. Use a 10mm deep socket to install the supplied ball
studs into the new coil covers.
154. Install the grommet supplied in Bag #6 in the hole
on the passenger side coil cover.
155. Slide the front fascia back into place and secure it
by reinstalling the stock fasteners, including: six body
pins and two bolts on top, three 10mm and two 7mm
bolts inside the fascia on each side and two 10mm bolts
on the underside.
156. Reconnect the fog light electrical connectors and the
fascia wiring harness connector on the passenger side.
157. Use a 10mm socket to reconnect the positive
battery terminal.
158. Use a 10mm socket to reconnect the negative
battery terminal.
159. Remove intercooler reservoir cap and fill intercooler
system with a 50/50 blend of water and coolant.
160. Refill the engine coolant system with a 50/50 blend
of water and coolant.
161. Reinstall and secure the front inner fender wells
with the stock fasteners.
Page 24
Brochure #63-1598
Rev. A - 2/12 - CP/mc
Advertisement
