Connection Guidelines For Ac-Powered Systems; Sfp Transceiver Specifications; Cisco Fibre Channel Sfp Transceivers - Cisco AJ732A - MDS 9134 Fabric Switch Installation Manual

Appendix B Technical Specifications
S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m

Connection Guidelines for AC-Powered Systems

For connecting the Cisco MDS 9100 Series switch AC power supplies to the site power source, follow
these basic guidelines:
•
•
•

SFP Transceiver Specifications

The Cisco MDS 9100 Series is compatible with SFP transceivers and cables that have LC connectors.
Each transceiver must match the transceiver on the other end of the cable in terms of wavelength, and
the cable must not exceed the stipulated cable length for reliable communications.
Cisco SFP transceivers provide the uplink interfaces, laser transmit (TX), and laser receive (RX), and
they support 850 to 1610 nm nominal wavelengths, depending upon the transceiver.
Use only Cisco SFP transceivers on the Cisco MDS 9100 Series. Each Cisco SFP transceiver is encoded
with model information that enables the switch to verify that the SFP transceiver meets the requirements
for the switch. For the list of supported SFP transceivers, see the release notes.
This section provides the following information:
•
•
•
For information about safety, regulatory, and standards compliance, see the Regulatory Compliance and
Safety Information for the Cisco MDS 9000 Family.

Cisco Fibre Channel SFP Transceivers

Table B-7
Cisco MDS 9124 Switch.
Table B-7
Part Number
DS-SFP-FC4G-SW
DS-SFP-FC4G-MR
DS-SFP-FC4G-LW
OL-17951-02
Each power supply should have its own dedicated branch circuit.
For international, circuits should be sized according to local and national codes.
The AC power receptacles used to plug in the chassis must be the grounding type. The grounding
conductors that connect to the receptacles should connect to protective earth ground at the service
equipment.
Cisco Fibre Channel SFP Transceivers, page B-5
Cisco Gigabit Ethernet/Fibre Channel Transceivers, page B-7
Cisco CWDM SFP Transceivers, page B-8
lists the Fibre Channel SFP transceivers available through Cisco Systems for the
Cisco Fibre Channel SFP Transceivers for the Cisco MDS 9124 Switch
Description
4-Gbps/2-Gbps/1-Gbps Fibre Channel–short
wavelength SFP
4-Gbps/2-Gbps/1-Gbps Fibre Channel–long
wavelength SFP
4-Gbps/2-Gbps/1-Gbps Fibre Channel–long
wavelength SFP
Type
Short wavelength
Long wavelength
Long wavelength
Cisco MDS 9100 Series Hardware Installation Guide
SFP Transceiver Specifications
B-5