Cisco AJ732A - MDS 9134 Fabric Switch Installation Manual page 78

Cisco MDS 9000 Family Telco and EIA Shelf Bracket
S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m
To install the shelf brackets in a telco rack, follow these steps:
Position a shelf bracket inside a rack-mounting rail as shown in
Step 1
the front of the shelf bracket with the holes in the rack-mounting rail. Then attach the shelf bracket to
the rack-mounting rail using a minimum of four 12-24 or 10-24 screws.
Note
Step 2 Repeat with the other shelf bracket.
Verify that the shelf brackets are at the same height (using the level or tape measure as desired).
Step 3
Attach the crossbar to the rear of the shelf brackets as shown in
Step 4
Cisco MDS 9100 Series Hardware Installation Guide
A-6
The bottom hole of the shelf bracket should align with the bottom hole of a rack unit on the
rack-mounting rail (the hole immediately above the 1/2-in. spacing).
Appendix A Cabinet and Rack Installation
Figure A-1 and align the screw holes at
Figure A-1, using the 10-32 screws.
OL-17951-02