Cisco AJ732A - MDS 9134 Fabric Switch Installation Manual page 47

Chapter 2 Installing the Cisco MDS 9100 Series
S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m
Insert the switch into the rack:
Step 2
a.
Figure 2-14
b.
Connect the power cord that you previously routed through the open cutout of the slider rail to the
Step 3
switch, as shown in
the rail opening.
Note
OL-17951-02
Using both hands, position the switch with the back of the switch between the rear rack-mounting
rails as shown in Figure 2-14.
Sliding the Cisco MDS 9134 Switch or the Cisco MDS 9124 Switch (Rear-Facing) on
the Notched Slider Rails
Front cabinet
mounting
rails
Align the two C brackets on either side of the switch with the slider rails installed in the rack. Slide
the C brackets onto the slider rails and then gently slide the switch all the way into the rack. If the
switch does not slide easily, try realigning the C brackets on the slider rails.
Figure 2-15. Limit the length of the power cord between the back of the chassis and
If you failed to route the power cord through the open cutout of the slider rail as directed in Step
1, remove the switch and rails and remount the rails using the correct method. Do not connect
the power cord by routing it over the top of the slider rail, as shown in
installation is hazardous.
Installing the Switch in a Cabinet with Insufficient Front Clearance
Rear cabinet
mounting
rails
Cisco MDS 9100 Series Hardware Installation Guide
Figure 2-16. This type of
2-19