Cisco AJ732A - MDS 9134 Fabric Switch Installation Manual page 37

Chapter 2 Installing the Cisco MDS 9100 Series
S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m
Insert the switch into the rack:
Step 5
a.
b.
Figure 2-4
OL-17951-02
By using both hands, position the switch with the back of the switch between the front
rack-mounting rails as shown in
Cisco MDS 9134 Switch or the Cisco MDS 9124 Switch, see
Align the two C brackets on either side of the switch with the slider rails installed in the rack. Slide
the C brackets onto the slider rails, and then gently slide the switch all the way into the rack. If the
switch does not slide easily, try realigning the C brackets on the slider rails.
Sliding the Cisco MDS 9100 Series onto the Slider Rails
Figure 2-4. If you are using the notched rails, for the
Cisco MDS 9100 Series Hardware Installation Guide
Installing the Switch in a Cabinet or Rack
Figure 2-5.
2-9