Installing An Ethernet Adapter - IBM 7947E3U User Manual

Installing an Ethernet adapter

To install an Ethernet adapter, complete the following steps:
1. Read the safety information that begins on page vii and "Installation guidelines"
on page 38.
2. Make sure that the server is turned off, all external cables and power cords are
disconnected, and the cover has been removed. For more information, see
"Turning off the server" on page 22 and "Removing the cover" on page 44.
3. Attach the rubber stopper on the location as shown in the illustration.
4. Remove the Ethernet adapter filler panel on the rear of the chassis (if it has
not been removed already).
5. Install the two standoffs on the system board.
6. Insert the bottom tabs of the metal clip into the port openings from outside the
chassis.
Rubber
stopper
Rubber
stopper
Ethernet
adapter connector
Chapter 2. Installing optional devices
109