Typical Operating-System Installation; Installing Your Operating System Without Using Serverguide - IBM 7947E3U User Manual

v Start the operating-system installation. You will need your operating-system CD.
Important: Before you install a legacy operating system (such as VMware) on a
server with an LSI SAS controller, you must first complete the following steps:
1. Update the device driver for the LSI SAS controller to the latest level.
2. In the Setup utility, set Legacy Only as the first option in the boot sequence in
3. Using the LSI Configuration Utility program, select a boot drive.
For detailed information and instructions, go to https://www-947.ibm.com/systems/
support/supportsite.wss/docdisplay?lndocid=MIGR-5083225.

Typical operating-system installation

The ServerGuide program can reduce the time it takes to install an operating
system. It provides the device drivers that are required for your hardware and for
the operating system that you are installing. This section describes a typical
ServerGuide operating-system installation.
Note: Features and functions can vary slightly with different versions of the
ServerGuide program.
1. After you have completed the setup process, the operating-system installation
2. The ServerGuide program stores information about the server model, service
3. The ServerGuide program presents operating-system partition options that are
4. The ServerGuide program prompts you to insert your operating-system CD and

Installing your operating system without using ServerGuide

If you have already configured the server hardware and you are not using the
ServerGuide program to install your operating system, complete the following steps
to download the latest operating-system installation instructions from the IBM Web
site.
Note: Changes are made periodically to the IBM Web site. The actual procedure
might vary slightly from what is described in this document.
1. Go to http://www.ibm.com/systems/support/.
2. Under Product support, click System x.
3. From the menu on the left side of the page, click System x support search.
4. From the Task menu, select Install.
5. From the Product family menu, select System x3650 M2.
6. From the Operating system menu, select your operating system, and then click
the Boot Manager menu.
program starts. (You will need your operating-system CD to complete the
installation.)
processor, hard disk drive controllers, and network adapters. Then, the program
checks the CD for newer device drivers. This information is stored and then
passed to the operating-system installation program.
based on your operating-system selection and the installed hard disk drives.
restart the server. At this point, the installation program for the operating system
takes control to complete the installation.
Search to display the available installation documents.
Chapter 3. Configuring the server
125