Logging On To The Web Interface; Enabling The Broadcom Gigabit Ethernet Utility Program - IBM 7947E3U User Manual

1. Turn on the server.
2. When the prompt <F1> Setup is displayed, press F1. If you have set both a
3. From the Setup utility main menu, select System Settings.
4. On the next screen, select Integrated Management Module.
5. On the next screen, select Network Configuration.
6. Find the IP address and write it down.
7. Exit from the Setup utility.

Logging on to the Web interface

To log on to the Web interface to use the remote presence functions, complete the
following steps:
1. Open a Web browser on a computer that connects to the server and in the
2. Type the user name and password. If you are using the IMM for the first time,
3. On the Welcome page, type a timeout value (in minutes) in the field that is
4. Click Continue to start the session. The browser opens the System Status

Enabling the Broadcom Gigabit Ethernet Utility program

The Broadcom Gigabit Ethernet Utility program is part of the server firmware. You
can use it to configure the network as a startable device, and you can customize
where the network startup option appears in the startup sequence. Enable and
disable the Broadcom Gigabit Ethernet Utility program from the Setup utility.
Note: Approximately 3 minutes after the server is connected to ac power, the
power-control button becomes active.
power-on password and an administrator password, you must type the
administrator password to access the full Setup utility menu.
address or URL field, type the IP address or host name of the IMM to which
you want to connect.
Notes:
a. If you are logging in to the IMM for the first time after installation, the IMM
defaults to DHCP. If a DHCP host is not available, the IMM uses the default
static IP address 192.168.70.125.
b. You can obtain the DHCP-assigned IP address or the static IP address from
the server UEFI or from your network administrator.
The Login page is displayed.
you can obtain the user name and password from your system administrator. All
login attempts are documented in the event log. A welcome page opens in the
browser.
Note: The IMM is set initially with a user name of USERID and password of
PASSW0RD (passw0rd with a zero, not the letter O). You have read/write
access. For enhanced security, change this default password during the initial
configuration.
provided. The IMM will log you off the Web interface if your browser is inactive
for the number of minutes that you entered for the timeout value.
page, which displays the server status and the server health summary.
Chapter 3. Configuring the server
129