Dot1X Port-Method - TP-Link JetStream L2 Lite TL-SG3210 Cli Reference Manual

no dot1x port-control
Parameter
auto | authorized-force | unauthorized-force —— The Control Mode for the port.
Auto: In this mode, the port will normally work only after passing the 802.1X
Authentication.
Authorized-force: In this mode, the port can work normally without passing the
802.1X Authentication.
Unauthorized-force: In this mode, the port is forbidden working for its fixed
unauthorized status.
By default, the Control Mode is auto.
Command Mode
Interface Configuration Mode（interface ethernet / interface range ethernet）
Example
Configure the Control Mode for port 1 as authorized-force:
TP-LINK(config)# interface ethernet 1
TP-LINK(config-if)# dot1x port-control authorized-force

dot1x port-method

Description
The dot1x port-method command is used to configure the Control Type of
IEEE 802.1X for the specified port. To restore to the default configuration,
please use no dot1x port-method command.
Syntax
dot1x port-method { mac-based | port-based }
no dot1x port-method
Parameter
mac-based | port-based ——The Control Type for the port.
Mac-based: Any client connected to the port should pass the 802.1X
Authentication for access.
Port-based: All the clients connected to the port can access the network on the
condition that any one of the clients has passed the 802.1X Authentication.
By default, the Control Type is mas-based.
71