Igmp-Snooping Vlan-Config - TP-Link JetStream L2 Lite TL-SG3210 Cli Reference Manual

member-time —— Member Port Time. Within this time, if the switch does not
receive IGMP report message from the member port, it will consider this port is
not a member port any more. Member Port Time ranges from 60 to 600 in
seconds. By default, it is 260.
leave-time —— Leave Time, which is the interval between the switch reveiving
a leave message from a host and the switch removing the host from the
multicast groups. Leave Time ranges from 1 to 30 in seconds. By default, it is 1.
router-port —— Static Router Port, which is mainly used in the network with
stable topology. It ranges from 1 to 10.
Command Mode
Global Configuration Mode
Example
Enable IGMP Snooping for VLAN 1, and configure Router Port Time as 200
seconds, Member Port Time as 100 seconds, Leave time as 10 seconds and
Static Router Port as port 1:
TP-LINK(config)# igmp-snooping vlan-config-add 1 rtime 200 mtime 100
ltime 10 rport 1

igmp-snooping vlan-config

Description
The igmp-snooping vlan-config command is used to modify IGMP Snooping
parameters for individual VLANs. To return to the primary configuration of the
corresponding VLAN, please use no igmp-snooping vlan-config command.
Syntax
igmp-snooping vlan-config {vlan-id} [rtime router-time] [mtime member-time]
[ltime leave-time] [rport router-port]
no igmp-snooping vlan-config {vlan-id}
Parameter
vlan-id —— The ID of the VLAN desired to modify configuration, ranging from
1 to 4094.
router-time —— Router Port Time. Within this time, if the switch does not
receive IGMP query message from the router port, it will consider this port is not
a router port any more. Router Port Time ranges from 60 to 600 in seconds. By
default, it is 300.
member-time —— Member Port Time. Within this time, if the switch does not
154