Mounting Bracket Procedure - AT&T SL82318 - DECT 6.0 Digital Three Handset Answering System User Manual

Getting started

Mounting bracket procedure

The telephone base comes with the mounting bracket installed for desktop
use. Wall mounting requires a telephone outlet wall mounting plate with
mounting studs that may require professional installation. You can purchase
the mounting plate from many hardware or consumer electronics retailers.
NOTE: The mounting bracket must be used for both tabletop and wall mounting positions.
Desktop to wall mount installation
To change the telephone base to the wall mount position:
1. Remove the cords from the routing
slots on the bracket.
Figure 1. Cords removed from the routing slots
3. Position your hands as shown in Figure 3. Press your thumbs down on the tabs Position your hands as shown in Figure 3. Press your thumbs down on the tabs
that are below the bracket, holding it in place. Use your index fingers to move
the bracket towards yourself.
Figure 3. Detaching the bracket from the telephone base
2. Place the telephone base on a flat
surface with the antenna on the left
side as shown in Figure 2.
Antenna
Figure 2. Desktop mounting bracket location
10