Table of Contents
Advertisement
English
•
An extremely large variation in the density and color tone of the
background of a check.
•
Many folds or wrinkles in a check.
•
Exposure of the image scanning part of the printer to strong
sunlight.
•
A foreign object, such as sand, entering the printer and
scratching the glass surface of the scanner.
CAUTION:
Do not insert checks with staples in them. This may cause paper jams,
MICR reading errors, and damage to the MICR head.
Be sure the checks are flat, without curls, folds, or wrinkles.
1. Wait until the SLIP light blinks. Then insert the check face up
with the right side of the check against the right side of the
paper guide as far as it will go. Be sure that the MICR
characters are on the right.
MICR
characters
on this side
face up
2. The printer will detect the check and start drawing it in. When
the printer starts drawing it in, let go of the check immediately.
When the printer ejects the check and the SLIP light starts
blinking again, remove the check by pulling it straight out; do
not pull it at an angle.
Cleaning the MICR Mechanism
Foreign matter in the mechanism can cause MICR reading errors.
Clean the MICR head with a moistened cleaning sheet
approximately every 12 months.
10 TM-H6000II with Image Scanner User's Manual
Advertisement
Table of Contents
