Eagle Fish ID 128 Installation And Operation Instructions Manual page 7

RATCHETS
remove the transducer and ratchets from the bracket. Place the ratch-
ets into the holes in the bracket with the letter "B" aligned with the dot
stamped in the bracket. Reassemble the transducer and bracket and
place them against the transom. Again, check to see if you can move
the transducer so it's parallel with the ground. If it does, then go to step
3. If it doesn't, repeat step 2, but use a different letter until you can
place the transducer on the transom correctly.
3. Once you determine the correct position for the ratchets, assemble
the transducer as shown below. Don't tighten the lock nut at this time.
METAL
WASHER
NUT
RUBBER
METAL
WASHERS
WASHER
BOLT
7