Epson AcuLaser C9300N User Manual page 100

Epson AcuLaser C9300 Series User's Guide
Preheat Mode
The printer is in the preheat mode. You can change the time to enter the mode on Time to Preheat
in Setup Menu.
Print Overrun
The required time to process the print data exceeded the print engine speed because the current page is
too complex. Press the Start/Stop button to resume printing, or press the W Pause/Cancel button
to cancel the print job. If this message appears again, select On as the Page Protect setting in the
control panel's Setup Menu or select Avoid Page Error on the printer driver.
If you continue to receive this message when printing a particular page, try simplifying the page by
limiting the number of graphics or reducing the number and size of fonts.
To avoid this error, it is recommended that you set the Page Protect setting to On and add more
memory to the printer. See "Setup Menu" on page 70 and "Memory Module" on page 124 for details.
PS3 CompactFlash Full
The memory allocated for writing PostScript 3 commands on the optional CompactFlash memory is
full.
To clear this error, select Clear Warning from the control panel's Reset Menu. For instruction
about accessing the control panel menus, see "How to access the control panel menus" on page 60.
RAM CHECK
The printer is checking the RAM.
Ready
The printer is ready to receive data and print.
Reboot to apply settings
You selected No when Do you want to reboot to apply the settings? was displayed.
To clear this error, select Clear Warning from the control panel's Reset Menu. See "How to access
the control panel menus" on page 60 for instructions.
Replace Dev Unit uuuu
Using the Control Panel 100