Epson WorkForce WF-2510WF User Manual page 100

User's Guide
D
Remove only the yellow tape.
c
Important:
❏ You must remove the yellow tape from the cartridge before installing it; otherwise, print quality may
decline or you may not be able to print.
❏ If you have installed an ink cartridge without removing the yellow tape, take the cartridge out of the
product, remove the yellow tape, and then reinstall it.
❏ Do not remove the transparent seal from the bottom of the cartridge; otherwise, the cartridge may become
unusable.
❏ Do not remove or tear the label on the cartridge; otherwise, ink will leak.
E
Insert the cartridge and press it until it clicks. Make sure the top surface of the ink cartridges align.
F
Close the scanner unit slowly and press OK. Ink charging starts.
Note:
❏ The P light continues to flash while the product is charging ink. Do not turn off the product during ink charging.
If the ink charging is incomplete, you may not be able to print.
❏ If you had to replace an ink cartridge during copying, to ensure copy quality after ink charging is finished, cancel
the job that is copying and start again from placing the originals.
Ink cartridge replacement is complete. The product will return to its previous status.
Replacing Ink Cartridges
100