Table of Contents
Advertisement
*1
If the length (L) defined as 1, be sure to set the ration of the width (W) between 1.25
and 1.5.
*2
Be sure to make the width of W1 (width of body pages / slip sheets) less than the width
of W2 (width of cover), when 3-direction cutting is done.
*3
For good looking finished booklets, the maximum length of cover you can set is 487.7
mm. 487.7 mm includes the total of the following values.
Length of body pages / slip sheets x 2, maximum booklet thickness (25 mm), and maxi-
mum value of cover image placement adjustment (5 mm).
#
IMPORTANT
Be sure to use paper that is less than 297 mm wide when cutting in one direction or
when not cutting.
Cutting range
For good looking finished booklets, be sure to set the top/bottom cutting range and
foredge cutting range as follows.
#
Top/bottom cutting range
Foredge cutting range.
If length of cover is longer
than the length of body
pages / slip sheets.
Foredge cutting range.
If length of cover is shorter
than the length of body
pages / slip sheets.
Examples of finished size of booklets (3-direction cutting)
The following table shows examples that the combination of cover and body pages / slip
sheets when 3-direction cutting is done.
C1 = W2 - W
Cutting range is width of
cover minus width of fin-
ished booklet.
C2 = (L2 - D) / 2 - L
Cutting range is length of
cover minus the booklet
thickness, divided by two.
And the length of the fin-
ished booklet is subtracted
from the result.
C2 = L1 - L
Cutting range is length of
body pages / slip sheets
minus length of finished
booklet.
Finished sizes of booklets
Chapter 3 - Basic operations
43
Advertisement
Table of Contents
