Problems with the printing quality
Image Edges are Blurred or White Banding Occurs
The Platen suction is too strong.
The Printhead is set too high.
Documents are printed crooked
Skew Skew Check Lv. has been set to Loose or
Off .
Width Detection has been set to Off .
White dots about 1 mm (0.039 in) apart appear on printed
documents, in the direction paper is fed.
The media type setting is incorrect.
Parts used in paper feeding (spurs) are soiled.
Immediately After Borderless Printing, the Trailing Edge
Margin is Soiled During Regular Printing
Depending on your printing environment, after
borderless printing in which the leading and trailing
edge of the roll is cut automatically, any ink adhering
to the cutter unit may rub off on the next printed
document.
670 Troubleshooting
Cause
Cause
Cause
Cause
Corrective Action
Set VacuumStrngth to Weakest . (→P.595)
Lower the Printhead . (→P.588)
Corrective Action
Choose Standard in Skew Check Lv. .
Choose On in Width Detection .
Corrective Action
After you select the correct media type, clean the
parts used in paper feeding (spurs).
(→P.162)
(→P.124)
(→P.644)
Clean the Spurs.
(→P.644)
Corrective Action
Follow these steps to set the Between Pages setting
of Drying Time in a range of 30 seconds to 3 minutes
before borderless printing.
1.
On the Main sheet of the printer driver, click
Settings in Media Type .
2.
Select the ink drying time in the Between Pages
list of Drying Time .